How To Clean A Taurus Millennium G2 9mm

WARNING: As a rule of thumb, whenever handling any firearm, treat the weapon as if it is loaded and be mindful of the muzzle of the firearm at all times! "I didn't know it was loaded" isn't an excuse and can't undo mistakes!

WARNING: As a dominion of thumb, whenever handling any firearm, treat the weapon as if it is loaded and be mindful of the muzzle of the firearm at all times! "I didn't know it was loaded" isn't an excuse and tin't undo mistakes!
Earlier proceeding with this repair, be sure to articulate the firearm of ammunition. Check, double check, and triple check to make sure there isn't a bullet in the chamber!
The Taurus G2C has a handy Loaded Bedchamber Indicator to show if there's a bullet in the bedchamber. Even if it'south not showing loaded doesn't mean you should non cheque!

For safety reasons, the serial number has been redacted.

For safety reasons, the serial number has been redacted.
Later on making certain the weapon is articulate -no bullet in the chamber- , release the striker by pulling the trigger. This releases the tension on the striker and allows the slide to come up frontward.
Pull the slide back just a pilus to release the tension on the disassembly latches. Pull downward on the disassembly latches on both sides while holding rearward pressure on the slide, and so release the pressure on the slide.

Proceed moving the slide forwards until the rear of the slide passes the guides the notches above the disassembly latches(pointed out in the terminal picture show).

The recoil spring assembly is on the lesser of the barrel. It is held in place by the spring's own tension against a notch in the barrel (2d picture) and its slot in the cease of the slide.
While holding the slide with the muzzle pointing away from you, put your thumb or alphabetize finger on the rear-facing portion of the recoil spring assembly. Push the associates forwards to complimentary it from the tension against the barrel, then release the tension and pull it out of its slot in the slide.

With the recoil leap assembly no longer holding the barrel in, the barrel can now be removed.
Move the barrel slightly towards the bottom of the slide
Push the barrel forward a little fleck to allow enough space to articulate the ejector (non pictured)

Lift the barrel out of the slide.

Always treat any gun as if it were loaded at all times. Also ever exist mindful of the direction your muzzle is pointed.
You're finished! Yous have now successfully field stripped a Taurus G2C.

Conclusion

To reassemble your weapon, follow these instructions in reverse society.